Skip to main content
M/T Change Lever Clearance Inspection

  1. Measure the clearance between change lever (A) and the select lever (B) with a feeler gauge (C). If the clearance is more than the service limit, go to Step 2 .
    Standard:
    0.05−0.35 mm (0.002−0.014 in.)
    Service Limit:
    0.55 mm (0.022 in.)


  1. Measure the groove width of the change lever.
    • If distance is not within the standard, replace the change lever with a new one.
    • If distance is within the standard, replace the select lever with a new one.
    Standard:
    13.00−13.15 mm (0.512−0.518 in.)