Skip to main content
M/T Differential Carrier Bearings Replacement

Special Tools Required

Commercially available
bearing puller

Inner driver handle, 40 mm
 07746-0030100
  1. Check the carrier bearings for wear and rough rotation. If they rotate smoothly and their rollers show no signs of wear, the bearings are OK.
  1. Remove the carrier bearings (A) with commercially available bearing puller (B).

  1. Install the new bearing (A) with the 40 mm inner driver handle and a press. Press each bearing on until it bottoms. There should be no clearance between the bearings and the carrier.
    NOTE: Turn the seal (B) part of the bearing to the outside of differential, and install it.