Skip to main content
Side Impact Sensor (First) Replacement

Removal
  1. Do the battery terminal disconnection procedure, then wait for 3 minutes before starting work.
  1. Remove the center pillar lower trim:
  1. Disconnect the floor wire harness 4P connector (A) from the side impact sensor (first) (B).
  1. Using a TORX T30 bit, remove the TORX bolt (C), then remove the side impact sensor (first).

Installation
  1. Install the side impact sensor (first) with a new TORX bolt (A), then connect the floor wire harness 4P connector (B) to the side impact sensor (first) (C).
  1. After installing the side impact sensor (first) confirm proper system operation: Turn the ignition switch to ON (II); the SRS indicator should come on for 6 seconds and then go off.
  1. Reinstall all removed parts.