Skip to main content
Side Impact Sensor (First) Replacement

Removal
  1. Do the battery terminal disconnection procedure, then wait at least 3 minutes before starting work.
  1. Disconnect the floor wire harness 2P or 4P connector (A) from the side impact sensor (first) (B).
    • 2P: With side airbag/without side curtain airbag
    • 4P: With side airbag and side curtain airbag
  1. Using a TORX T30 bit, remove the TORX bolt (C), then remove the side impact sensor (first).

Installation
  1. Install the new side impact sensor (first) with a new TORX bolt (A), then connect the floor wire harness 2P or 4P connector (B) to the side impact sensor (first) (C).
    • 2P: With side airbag/without side curtain airbag
    • 4P: With side airbag and side curtain airbag
  1. After installing the side impact sensor (first) confirm proper system operation: Turn the ignition switch to ON (II); the SRS indicator should come on for about 6 seconds and then go off.
  1. Reinstall all removed parts.