Skip to main content
Speaker Test/Replacement

Front/Rear Door Speaker
  1. Remove the door panel:
  1. Remove the bolt. Then lift the speaker (A) straight up to release the lower clips (B).
    If you pull the speaker out too far from the door, you will damage the lower clips.
  1. Disconnect the 2P connector (C), and remove the speaker.
  1. Measure the resistance between the terminals No. 1 and No. 2. There should be about 4 Ω.
  1. If the resistance is not as specified, replace the door speaker.

Front Tweeter
NOTE:
  • Be careful not to damage the front tweeter grille and the dashboard.
  • When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
  1. Carefully pry the tweeter grille (A) out of the dashboard.
  1. Disconnect the 2P connector (B) from the front tweeter.

  1. Remove the front tweeter (A) from the speaker grille (B).
  1. Check the capacitor condition. If any malfunction is found, replace the front tweeter.

  1. Measure the resistance between the front tweeter (A) terminal No. 2 and the outside terminal of the capacitor. There should be about 4 Ω.
  1. If the resistance is not as specified, replace the front tweeter.