Skip to main content
Exterior Light Bulb Replacement

HID Bulb
A transient high tension (25,000 V) occurs at the bulb sockets of the high intensity discharge (HID) lamps when the combination light switch is turned ON, it may cause serious electrical shock or electrocution if you do not observe the cautions below.

  • Never turn on the combination light switch before fitting the HID bulbs to their bulb sockets and completing the reassembly of the headlight assembly.
  • Do not service the headlights assembly in wet conditions, such as rain or snow, near a sprinkler system, or when your hands are wet to prevent electrocution.
  • Do not touch the surface of the HID bulbs with your bare hands and do not stain it with any oils and fats.
  • Do not disassemble the inverter unit and the ignitor unit.
  • Do not turn on the HID bulb by using a power source other than the battery mounted on your vehicle.

  1. Turn the combination light switch OFF.
  1. Turn the ignition switch to LOCK (0).
  1. Turn the cover (A) 45 ° counterclockwise to remove it from the headlight assembly.

  1. Turn the socket (A) 45 ° counterclockwise to remove it from the bulb (B).
    Headlight:
    35 W

  1. Pull the retaining spring (C) away from the bulb then remove the bulb.
  1. Install a new bulb in the reverse order of removal. Make sure the notches in the bulb align with the tabs in the headlight.
  1. Install the parts in the reverse order of removal.

Taillights (LED type)
  1. Open the tailgate and remove the maintenance lid (A).

  1. Disconnect the connectors from the lights.
    Brake Light/Taillight:
    (LED)
    Rear Turn Signal Light:
    21 W
    Back-up Light:
    21 W
    Rear Fog Light:
    21 W

    NOTE: The brake light/taillight (LED) is a part of the taillight assembly, and it cannot be replaced itself.
  1. Turn the bulb socket (A) 45 ° counterclockwise to remove the bulb (B).
  1. Install new bulb(s) in the reverse order of removal.