Skip to main content
High/Low Beam Switching Solenoid Replacement

  1. Disconnect the high/low beam switching solenoid 2P connector (A).
  1. Place a clean shop towel or paper (B) under the high/low beam switching solenoid.
  1. Slightly push down the headlight reflector to secure the space.

  1. Remove the two screws (A) from the high/low beam switching solenoid (B).
  1. Disconnect the 1P terminal (C) and remove the high/low beam switching solenoid.
    NOTE: Do not touch the hood and the moving part. It is necessary to clean if touch the parts.
  1. Install the switching solenoid in the reverse order of removal.