Skip to main content
Mirror Holder Replacement

NOTE:
  • Put on gloves to protect your hands.
  • Take care not to scratch the power mirror and related parts.
  • LHD model is shown; RHD model is symmetrical.
  1. Carefully push on the top edge of the mirror holder (A) by hand.
  1. Put a shop towel in the opening between the lower edge of the mirror holder and the mirror housing to prevent scratches, and detach the bottom hooks (B) with a flat-tip screwdriver wrapped with protective tape.

  1. Carefully pull out the bottom edge of the mirror holder (A) to separate the adhesive (B), and then release the side clips (C).
  1. Separate the mirror holder from the actuator (D) by releasing the hooks (E). If equipped, disconnect the mirror defogger terminals (F).

  1. If necessary, remove the skull cap (A).
    -1.
    Remove the tabs (B) from inside the mirror housing (C).
    -2.
    Release the hook (D), then remove the skull cap.