Skip to main content
Glass Roof Sunshade Calibration

NOTE: The sunshade calibration must be performed when any of the following events have occurred.
  • The sunshade motor is replaced with a new one.
  • Any component related to the sunshade replaced.
  • -
    Sunshade bracket
    -
    Sunshade cables, etc.
The sunshade will reverse while it is closing
  1. Turn the ignition switch to ON (II).
  1. Press and release the sunshade AUTO CLOSE switch.
    NOTE: The sunshade will reverse and stop while closing.
  1. Press and hold the sunshade CLOSE switch for more than 13 seconds.
    NOTE: The sunshade moves to close position by the jog operation * , then stop in fully closed position.
    *:
    moves 40 mm, stops 0.4 seconds, then repeats

  1. Release the CLOSE switch. Within 5 seconds, press and hold the CLOSE switch again.
    NOTE: The sunshade moves to fully open position, then it moves to fully closed position.
  1. Calibration is complete.
The sunshade will stop while it is operated
  1. Turn the ignition switch to ON (II).
  1. Press and release the sunshade AUTO CLOSE switch.
    NOTE: The sunshade will stop while it is operated.
  1. Press and hold the sunshade CLOSE switch for more than 13 seconds.
    NOTE: The sunshade moves to close position by the jog operation * , then stop in fully closed position.
    *:
    moves 40 mm, stops 0.4 seconds, then repeats

  1. Release the CLOSE switch. Within 5 seconds, press and hold the CLOSE switch again.
    NOTE: The sunshade moves to fully open position, then it moves to fully closed position.
  1. Calibration is complete.