Skip to main content
Glass Roof Sunshade Drive Shoe Replacement

NOTE:
  • Take care not to scratch the sunshade plate.
  • Even if old sunshade is to be reused, the shoes should be replaced with new ones.
Drive shoe/front shoe/rear shoe
  1. Fold the four claws (A) on the shoe cover from the drive shoe (front shoe) (B) side with a flat-tip screwdriver wrapped with protective tape, then push them in. Take care not to deform the square holes in the sunshade plate during this work.

  1. Turn over the sunshade plate, and remove the shoe cover (A) and the drive shoe (front shoe) (B) from the sunshade plate (C) using the flat-tip screwdriver wrapped with protective tape. Remove the rear shoe and the shoe cover in the same way.

  1. Taking care of installation direction, align the new drive shoe (front shoe) or the new rear shoe (A) with the square holes (B) not to deform them, then install.
    Interior side (Interior color surface)
    Outside (Black color surface)
    Sunshade plate A
    Front
    Drive shoe
    Shoe cover
    Rear
    Shoe cover
    Rear shoe
    Sunshade plate B
    Front
    Front shoe
    Shoe cover
    Rear
    Shoe cover
    Rear shoe
    Sunshade plate C
    Front
    Front shoe
    Shoe cover
    Rear
    Shoe cover
    Rear shoe B


  1. Hitch the hook (A) of the new shoe cover (B) to the sunshade plate (C), push the square holes on the shoe and install securely.

Middle shoe
  1. Remove the middle shoe (A), from sunshade plate (B).

  1. Align the inside rid (A) of the new middle shoe (B) with the cutout (C) of the sunshade plate, and install the middle shoe with projections (D) in the interior side (interior color surface).

  1. Replace the drive shoe (B), middle shoe (C), rear shoe (D), and shoe covers (E) on the sunshade plate A following step 2 through step 7.

  1. Replace the front shoe (A), middle shoe (C), rear shoe (D), and shoe covers (E) on the sunshade plate B following step 2 through step 7.

  1. Replace the front shoe (A), middle shoe (B), rear shoe (D), and shoe covers (E) on the sunshade plate C following step 2 through step 7.

  1. After installing the drive shoe (front shoe), middle shoe, rear shoe, make sure that the matching face (A) of each shoe is the same level.