Skip to main content
Glass Roof Sunshade Plate Replacement

NOTE:
  • Put on the gloves to protect your hands.
  • Take care not to scratch the seat, dashboard, body and other related parts.
  1. Close the sunshade fully.
  1. Remove the glass roof sunshade frame.
  1. Push the lock (A) and move the spring base (B) in the direction of an arrow.

  1. Raising the end (A) of the torsion spring (B), move the spring base (C) and remove the spring base and the torsion spring from the stage (D).

  1. Turn to open the clamp (A) on the drive shoe (B) and detach the slider (C) from the drive shoe. Detach from both sides.

  1. Make sure that the sliders are detached from the drive shoes, then slowly push the sunshade plate A rearward.
  1. Push the sunshade plate A rearward furthermore until both the sunshade plate B and the sunshade plate C are raised.

  1. Pull the rear portion of the sunshade plate C rearward until the rear shoe B comes off from the stage, then raise and remove the sunshade plate C. Remove the front portion of the sunshade plate along with the rail (A) on the stage.

  1. Pull the rear portion of the sunshade plate B rearward until the rear shoe A comes off from the stage, then raise and remove the sunshade plate B. Remove the front portion of the sunshade plate along with the rail (A) on the stage.

  1. Pull the rear portion of the sunshade plate A rearward until the rear shoe B comes off from the stage, then raise and remove the sunshade plate A. Remove the front portion of the sunshade plate along with the rail (C) on the stage.

  1. Apply multipurpose grease to the sliding surface (shaded area) (B) of the shoe on the stage (A) on both sides.

  1. Insert the drive shoe of the sunshade plate A along with the rail (C) on the stage, then insert the rear shoe B in the rail.
  1. Slowly pull the center of the front portion of the sunshade plate A, taking care not to deform it, and slide it forward by 100 to 300 mm (3.9 to 11.8 in.).

  1. Install the sunshade plate B in the same way as Step 12 .
  1. Slowly pull the center of the front portion of the sunshade plate A, taking care not to deform it, and make sure that the rear shoe (C) of the sunshade plate A and the front shoe (D) of the sunshade plate B are connected.

  1. Also, slowly pull the center of the front portion of the sunshade plate A, taking care not to deform it, and slide the sunshade plate B forward by 100 to 300 mm (3.9 to 11.8 in.).
  1. Install the sunshade plate C in the same way as Step 12 .

  1. Slowly pull the sunshade plate A in the same way as Step 15 , and make sure that the rear shoe (D) of the sunshade plate B and the front shoe (E) of the sunshade plate C are connected. Pull the sunshade plate A to slide sunshade plate assembly until it is closed.

  1. Fully pull the sunshade plate A to fit the slider (B) to the clamp (C) on the drive shoe.
  1. Securely lock the clamps on the drive shoe on both sides, and connect the drive shoe to the cable.

  1. Install the torsion spring (A) on the stage (B).
  1. Insert the spring base (C) in the torsion spring on the stage, and securely fix it with the lock (D) on the stage.